Audi 80/Avant
+ The description
+ Engines
+ System of release of the fulfilled gases
+ Cooling system
+ Fuel tank and the fuel pump
+ The air filter and воздухозаборные channels
+ Injection system
+ Coupling
+ Transmission and transmission
+ Suspension bracket and steering
+ Brake system
+ Antiblocking system of brakes
+ Wheels and tyres
+ Kuzovnaja electrosystem
+ Ignition system
+ Illumination
+ Signalling devices
+ Devices and auxiliary devices
+ Heating and ventilation
- Body elements
Forward bumpers
Forward part of the car
Cowl
Wings
Молдинги
Doors
External rear-view mirrors
The forward and back has flown down
Cover of a luggage carrier at a sedan
Back door of the versatile person
Back bumper
The sdvizhnoj hatch
Procleaning of apertures for a water drain
The control of anticorrosive protection of the bottom of a body
Salon
Seats
+ Search of malfunctions
+ Specifications
|
Wings
|
|
The wing (3) is presented in drawing together with hinged details:
1 – a back face overlay;
2 – подкрылок. |
Demountable forward wings are executed only. Back wings are welded, here again there is nothing to do to mechanics-fans.
Removal of facing of forward wheel niches
|
|
To remove a corresponding forward wheel.
To remove plastic дюбель at the very bottom on back to bumper edge.
To remove боковины a bumper from arms on a wing. For this purpose to press on a bumper in a direction downwards at height of fixture and simultaneously to take away it from a body.
To turn away all fixing bolts/nuts of facing of a wheel niche (подкрылок).
To remove plastic дюбели a forward bolt.
In front to turn away a fixing nut подкрылка.
To turn a rotary lock on connection with the bottom protection of a motor compartment on 90 counter-clockwise (to the left).
To remove facing of a wheel niche through распорный a bolt and to wring out inside from an external contour of a wheel arch.
At installation very cautiously to tighten plastic nuts and bolts with crosswise шлицем, differently it is possible to break a plastic carving!
|
|
Wing removal
|
|
To remove подкрылок.
To remove a bumper.
To turn out on bottom to wing edge on one screw with crosswise шлицем or screws with звездчатой a head in front and behind.
To turn out the screw below cut for a bumper.
In a back part of a wheel niche to turn out the screw from a cross-beam, and one more a bit more low.
To open a forward door.
To turn out a bolt over hinges.
To turn out шестигранные bolts on a wing upper edge; before it to remove поролонную a lining.
To remove a wing.
|
|
Installation covered
|
|
If the new wing is established, it is necessary to remove an arm and a back face overlay from an old wing and приклепать (in a workshop) to the new.
To remove the rests of a sealing tape on back edge of fastening of a wing.
To paste a new sealing cord (number spare parts AKD497 010 04R10) diameter 7 mm.
To establish a wing.
To establish distance to a cowl at not tightened fixing bolts of an upper edge of a wing. It should make 4,5—5,5 mm.
|
|
|
|
