Audi 80/Avant (B4)

Since 1991-1995 of release

Repair and car operation



Audi 80/Avant
- The description
   Engines
   Transmissions
   Body
   The chassis
   15-inch wheels
   Brake system
   Seats
   Passive safety
   Full drive
   Distributive Torsen-differential
   Dynamics of movement at a dry road covering
   Instructions on operation for all-wheel drive cars
   Blocking of differential of the back bridge
   Motor compartment
   Regular servicing
   The workplace organisation
   Lubricant works
   The oil expense
   Correct choice of engine oil
   Replacement of engine oil and the oil filter
   Check of level of a working liquid of the amplifier of a wheel
   Check of level of oil of a mechanical transmission
   Check of level of oil in a drive of the back bridge
   The control of level ATF in an automatic transmission
   Check of level of oil in the main transfer of an automatic transmission
   Replacement ATF
   Greasing тросовых drives, hinges and locks
+ Engines
+ System of release of the fulfilled gases
+ Cooling system
+ Fuel tank and the fuel pump
+ The air filter and воздухозаборные channels
+ Injection system
+ Coupling
+ Transmission and transmission
+ Suspension bracket and steering
+ Brake system
+ Antiblocking system of brakes
+ Wheels and tyres
+ Kuzovnaja electrosystem
+ Ignition system
+ Illumination
+ Signalling devices
+ Devices and auxiliary devices
+ Heating and ventilation
+ Body elements
+ Search of malfunctions
+ Specifications


a13f00c7

Check of level of a working liquid of the amplifier of a wheel

Constant check

Level of a working liquid (№ G 002 000) is checked in the transparent capacity located in the left part of a motor compartment.

 PERFORMANCE ORDER

    For the control of level of a liquid to leave the engine to idle. To put wheels in direct position. The liquid should be between marks max and min. The marks located sideways are visible not at all models. In this case it is necessary to use probe, being under a tank cover. To turn off a cover (it is cautious, a spring) to wipe probe a pure rag, a cover to put on a bulk aperture (not to fasten). Again to uncover and check up oil level on probeе. It should be between marks. If necessary to add a liquid to a mark max. In any case loss of a working liquid specifies in a leak in system. In this case it is important to find at first a leak place, and only then to add a liquid.