|
Tension клинового a belt
By moderate pressing by a thumb on клиновой it can be pressed through a belt between two pulleys as follows:
|
The engine
|
Klinovoj belt for
|
Belt sagging under thumb pressing, nearby
|
|
4-cylinder to сент. 91
|
The generator
|
10 mm
|
|
All 4-cylinder
|
The water pump, the hydraulic booster pump
|
5 mm
|
|
All 4-cylinder
|
The conditioner compressor
|
5 mm
|
|
5-cylinder
|
The generator
|
5 mm
|
|
5-cylinder
|
The pump гидроусислителя
|
5 mm
|
|
5-cylinder
|
The conditioner compressor
|
5 mm
|
If it is established new клиновой a belt, it is necessary to check its tension approximately through 100 km and if necessary дозатянуть; new belts are first extended more strongly.
Tension поликлинового a belt
Poliklinovoj belt of the 4-cylinder engine of the model which have been let out after September 91г., at the control it is necessary to pull anew. So it is necessary to weaken a belt and to establish a tension under the scheme described in the following paragraph.
The poliklinovoj belt of the 6-cylinder engine always has a correct tension thanks to the automatic device of a tension.
|
