+ The description
+ System of release of the fulfilled gases
+ Cooling system
+ Fuel tank and the fuel pump
+ The air filter and воздухозаборные channels
+ Injection system
+ Transmission and transmission
+ Suspension bracket and steering
+ Brake system
+ Antiblocking system of brakes
+ Wheels and tyres
+ Kuzovnaja electrosystem
+ Ignition system
Replacement of lamps
Removal of headlights
Check of adjustment of headlights
Independent installation of antifog headlights
Indexes of turns
Illumination of licence plates
Other lighting devices
Illumination of the instrument panel
+ Signalling devices
+ Devices and auxiliary devices
+ Heating and ventilation
+ Body elements
+ Search of malfunctions
Replacement of lamps of back lanterns
To remove a cartridge (1) after отжатия a rotary latch (arrow).
The cartridge of a headlight (2) is separated from the case of a headlight (1).
The switch of a headlight of a backing (marksman) is on the top party of a transmission. On this illustration we look in a gleam between the engine and a back wall of a motor compartment.
Illumination in a cover of a luggage compartment:
1 – an aperture for installation in the fixture case;
2 – a lamp cartridge;
3 – a lamp накаливания.
External back lanterns: to turn a rotary latch on the left and to remove a cartridge.
Lanterns in a cover of a luggage compartment: at first to disconnect a cover.
To turn a lamp cartridge approximately on 30 to the left (counter-clockwise) and to extend.
Replacement of lamps passes in all cases equally – slightly to press a lamp in its cartridge, to turn to the left and to take out.
At installation двухнитевой of a lamp for a stoplight and back dimensional fires pay attention that their lateral fixing pins are located at various height. Thanks to it it is possible to put a lamp without effort only in one certain position.
External back lanterns: to take out a lamp cartridge (the previous section see).
To turn away a covering of a luggage carrier in the field of back fires.
To turn out four шестигранных nuts from outside a luggage compartment.
To remove outside the case of fixtures. If it has stuck to a body because of the laid sealing cord, it is necessary to hook its screw-driver wrapped up in a rag.
Separate fixtures on a cover of a luggage compartment: to remove a cartridge () lamps (the previous section see).
To remove замковый an element at the right back headlight, having weakened two шестигранных a bolt.
To turn out in total four шестигранных nuts from the interior of a cover.
These back headlights also can stick to a body because of a sealing cord – to hook a screw-driver.
At installation it is necessary to use a new sealing cord.
Strip of fixtures on a cover of a luggage compartment: to operate the same as and at removal of separate headlights, it is unique that it will be necessary to disconnect большее quantity of bolts.